Stampin' Up! Accessories
- Simply Scrappin' Kit - Home Again
- Chocolate Chip cardstock (part of kit)
- Very Vanilla Taffeta Ribbon
- Chocolate Chip Taffeta Ribbon
- Mellow Moss Taffeta Ribbon
- Twill Tape (Medium Size)
- Rhinestone Brads (Circle, Ice Collection)
- Vintage Brads (Antique brown/brass color)
- Photo Corners Punch
Dimensions
- Left Side: Designer Series Paper is 2 1/4 x 3 3/4.
- Right Side: Chocolate Chip is 3 1/2 x 4 (and inner Designer Series Paper is 3 1/4 x 3 3/4).
Instructions
- Trace the back side of the "A" and the front side of the "M" in blue textured cardstock. Remember to trace/mark where the holes are in the chipboard (you will later punch them and set eyelets).
- Cut out and adhere to chipboard.
- On the back side of the "A", adhere a small border sticker strip across the bottom.
- Adhere the DSP and punched Chocolate Chip textured photo corner.
- Adhere a rectangular tag sticker.
- Then adhere layered stickers to the upper left corner. Use dimensionals if desired (I did not here).
- Punch the holes previously marked, then place and set eyelets for the "A".
- For the "M", again, using the same small sticker border, adhere along bottom.
- Adhere another sticker border towards the middle.
- Ahere the chocolate chip and striped DSP paper.
- In the upper right corner of the photo place holder, adhere a rectangler tag with Very Vanilla taffeta ribbon (knotted). Then adhere a few layered circular stickers, piercing them with a vintage brad. Ahere with dimensional.
- In the upper left corner of the photo place holder, adhere layered stickers again.
- At the top of the page, adhere the "Home" brown tag sticker with Mellow Moss taffeta ribbon knotted.
- In the upper side of the "M", wrap a piece of thick twill tape around. Then cover with a knotted Chocolage Chip taffeta piece of ribbon.
Thanks for visiting!
Heather
0 comments:
Post a Comment