Hand Stamped By Heather Wright-Porto: Frosty/Snowflake Photo Holder

Sunday, December 21, 2008

Frosty/Snowflake Photo Holder

As promised, this is the 3rd photo holder, similar to the first one. It again uses the retired Frosty set, but you can substitute Frosty for your own favorite holiday character or stamp!

Products Used
  • Frosty stamp set (retired)
  • Warmest Regards stamp set (retired, hostess set)
  • Wrought Iron punch (retired)
  • Snowflake punch
  • Bashful Blue cardstock
  • Whisper White cardstock
  • Bashful Blue, Only Orange, Real Red, Garden Green Stampin' Write Markers
  • Paper Snips
  • SNAIL Adhesive
  • Stampin' Dimensionals
  • Dazzling Diamond glitter
  • Two-way Glue Pen

Non-Stampin' Up! Product

  • Decorative Trimmer by Creative Memories
  • Cuttlebug
  • Snowflakes Embossing Folder (Cuttlebug)


  1. Cut standard card in Bashful Blue cardstock.
  2. Cut a 4 inch by 5 1/4 inch piece of Whisper White cardstock and put thru Cuttlebug with Snowflakes embossing folder.
  3. Then, using the Wrought Iron punch, punch each of the 4 corners. Trim and insert your photo.
  4. Adhere panel to card front.
  5. Punch 3 snowflakes, glitter, and adhere using Dimensionals in the upper left corner area.
  6. Cut a piece of Whisper White cardstock, 3 inches by 5 1/4 and use the Creative Memories trimmer to make the "wave". Stamp greeting. Glitter the edge, then adhere piece to photo bottom.
  7. Stamp Frosty image, color with markers, glitter, and cut out. Then adhere to bottom right corner with glue and also Dimensionals.

Thanks for visiting!